Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

Effect
The command is not processed.
Recovery
Use the ALTER SERVER command to change the BACKUPCPU attribute, and reissue the CONTROL
SERVER command with the SYNC option.
58
OSS E00058 The migration of a primary or a backup Name Server server
to a different processor failed.
server
identifies the affected server process.
Cause
A Subsystem Control Facility (SCF) CONTROL SERVER command was entered, but the backup
OSS name server process is not in a valid state.
Effect
The command is not processed.
Recovery
Retry the command at a later time. If that does not work, stop (unmount) all the filesets mounted
by that OSS name server and restart them.
59
OSS E00059 Unable to make all the volumes in the POOL edit file eligible
for file creation
Cause
A Subsystem Control Facility (SCF) CONTROL FILESET command was entered, but one or more
of the disk volumes configured to be in the storage creation pool for the fileset cannot be used
to store newly created OSS files. The storage pool for the fileset previously approached the limit
of 256 disk volumes and the storage creation pool configuration now contains one or more new
disk volume names.
Effect
The command is not processed.
Recovery
Use the SCF STATUS FILESET command with the DETAIL option to check the number of volumes
in the storage pool. If the storage pool has reached its disk volume limit but the fileset requires
space for new files, possible actions include:
• Delete unused files from the fileset to free space on disk volumes already in the storage
creation pool, remove the new disk volumes from the storage pool file, then reenter the
CONTROL FILESET command.
• Move files from this fileset to another fileset with more growth capacity to free space on
disk volumes already in the storage creation pool, remove the new disk volumes from the
storage pool file, then reenter the CONTROL FILESET command.
60
OSS W00060 The fileset is started, but MAXINODES value is changed to
maxinodesvalue
maxinodesvalue
indicates the MAXINODES value being used. This value is also stored in the configuration
database for the fileset.
OSS Monitor Messages 377