Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

B Manually Setting Up an OSS Environment
“Creating a Basic OSS Environment Without Using the OSSSETUP Utility” summarizes the procedures
for configuring and starting a new OSS environment by using manually entered operator commands
instead of the OSSSETUP utility. “Completing a Preconfigured Basic OSS Environment” (page 390)
summarizes the procedures for completing a new OSS environment preconfigured by HP or created
by the OSSSETUP DEFAULTS command. Be careful when using DSM/SCM in a network of systems
running both G-series RVUs and J-series or H-series RVUs; the default for Manage OSS Files is
unchecked for G-series RVUs and checked for J-series and H-series RVUs.
Creating a Basic OSS Environment Without Using the OSSSETUP Utility
Ensure Target System is Ready for Software Updates
ReferenceSubtask
Guardian User’s GuidePerform all site preparation procedures, such as backups
Update DSM/SCM If Necessary
If necessary, update DSM/SCM (product T6031) to the D46 product version update (PVU) or a
later PVU.
ReferenceSubtask
DSM/SCM User’s GuidePerform all DSM/SCM steps
Install Current Guardian Product Files
ReferenceSubtask
NonStop Software Essentials Installation and Quick Start
Guide or DSM/SCM User’s Guide
Perform all software installation steps without selecting the
Manage OSS Files check box
NonStop Software Essentials Installation and Quick Start
Guide or DSM/SCM User’s Guide
Perform a cold start if necessary
Prepare for Configuration
ReferenceExampleSubtask
Guardian User’s Guide>LOGON SUPER.SUPERLog on as the super ID
Verify that the system has these
resources, at minimum:
• 64 MB memory for each processor
• 10 GB disk space for the root
fileset
Verify that the system is running the
software release version update (RVU)
documented in this guide
1. To determine the complete filename
of correct version of RLSEID file, at
the TACL prompt, enter FILEINFO
$SYSTEM.SYS*.RLSEID.
2. Enter FUP COPY filename to
display the release ID.
Safeguard Administrator’s ManualVerify that the system has the
Safeguard product or third-party
386 Manually Setting Up an OSS Environment