Open System Services NFS SCF Reference Manual

Open System Services NFS SCF Reference Manual—522582-001

2-1

SCF Commands for OSS NFS

This section contains the following information:

•

A table describing the Subsystem Control Facility (SCF) commands supported by

the OSS NFS subsystem and the object types applicable to each command

•

Instructions for entering SCF commands

•

The following detailed information about each SCF command that you can use to

configure and control the OSS NFS subsystem:

A description of the command function

The command syntax

The object-spec, which shows the object type and object name

Considerations for using the command

Descriptions of the attribute-specs

Examples of using the command

Supported Commands and Object Types

This manual describes the SCF commands interpreted specifically for the OSS NFS

subsystem. The Subsystem Control Facility (SCF) Reference Manual (for D-series

releases) and the SCF Reference Manual for G-Series Releases provide information

about SCF commands generally supported by SCF; for example, the ASSUME, HELP,

and ENV commands. You should be familiar with that information before reading the

subsystem-specific information provided here. Table B-1

in Appendix B shows the

subsystem-specific commands and general SCF commands.

Detailed syntax information on the OSS NFS object types and the commands that apply

to them is provided when you type the following command:

HELP NFS [ command ] [ object-type ]

Table 2-1 lists the SCF commands supported by OSS NFS and the object types to which

each SCF command applies.