Open System Services NFS SCF Reference Manual

SCF Commands for OSS NFS
Open System Services NFS SCF Reference Manual—522582-001
2-51
INFO SERVER Command
Ext Mem Swap Vol is the swap volume used for the process extended memory
segment (as specified in the SWAPVOL parameter of the
PARAM or RUN command).
Primary is the number of the primary processor.
Backup is the number of the backup processor. A value of -1 indicates no
backup processor is defined and the NFS manager process is not
being run as a process pair.
Backup Debug indicates whether the backup process should (ON) or should not
(OFF) be initiated in debug mode.
Debug On Error indicates whether the program enters (ON) or does not enter
(OFF) debug mode when a fatal error occurs.
INFO SERVER Command
The INFO SERVER command displays the current attribute values for the specified
SERVER objects.
You can display attribute information about SERVER objects with or without detail.
The information contained in the displays produced by INFO SERVER is described in
detail under “Examples
on page 2-52.
The INFO SERVER command has the following syntax:
SERVER server-name
specifies the name of the SERVER object for which attribute information is
requested.
DETAIL
specifies that detailed SERVER attribute information is requested.
SEL [ NOT ] state
specifies the summary state select option. You can use the SEL option to specify that
you are requesting attribute information about only SERVER objects in a specified
summary state. See Summary States
on page 1-7 for the names and descriptions of
these states.
Note. An asterisk (*) in any INFO command display indicates that you can change the value of
the attribute using the ALTER command.
INFO SERVER server-name [ , DETAIL ]
[ , SEL [ NOT ] state ]