Open System Services Shell and Utilities Reference Manual (G06.28+, H06.05+)

gencat(1) OSS Shell and Utilities Reference Manual
value:\n\t\%s\n
gencat: The set number in the following line is not valid:\n\t\%s\n
gencat: The length of the hex number in the following line is not
valid.\n\
It must be either two or four digits.\n\t\%s\n
gencat: Reached end of line before the defined closing quote.\n\t\%s\n
gencat: The following message string is longer than
NL_TEXTMAX:\n\t\%s\n
gencat: Reached end of string before expected.\n\t\%s\n
gencat: Internal error: The file pointer offset is not correct.
gencat: Cannot load the catalog file \%x.\n
gencat: Cannot the existing catalog file \%s.\n
gencat: There is not enough memory available now.
gencat: The following set uses a symbolic identifier:\n\t\%s\n
gencat: The following message uses a symbolic identifier:\n\t\%s\n
gencat: There is no message defined in a source file.
gencat: Set or message numbers are not in ascending sequence after:
\n\tMessage: \%d, Set: \%d\n\t\%s
EXIT VALUES
The gencat utility returns a 0 (zero) on successful completion; otherwise it returns a 1 and gen-
erates a diagnostic message. When gencat reports an error, it takes no action on any commands
and leaves an existing catalog unchanged.
RELATED INFORMATION
Commands: mkcatdefs(1).
STANDARDS CONFORMANCE
The following are HP extensions to the XPG4 Version 2 specification:
• The escape sequence \xdddd is supported for compatability with OSF/1.
4−6 Hewlett-Packard Company 527188-007