Open System Services Shell and Utilities Reference Manual (G06.28+, H06.05+)

User Commands (m - o) osh(1)
The default mode is the DEFINE mode in effect for osh.
Refer to the TACL Reference Manual for additional information about Guardian
DEFINEs.
-extswap pathname
Specifies a Guardian swap file or swap volume for the extended data segment of
the child process. This option is no longer used but is retained for compatability
with older versions of the command. The pathname must be specified in OSS
pathname syntax.
The default action is to use the swap volume specified in the =_DEFAULTS
DEFINE values for the child process. If that volume is not available, the operat-
ing system chooses a swap volume.
Refer to the Guardian Programmer’s Guide for additional information about swap
files.
-gpri n Assigns the initial Guardian execution priority n (1-199) to the child process. The
value 1 is the lowest priority; the value 199 is the highest priority.
The default priority is the priority used for osh.
-highpin on | -highpin off
Specifies whether the child process can run with a Guardian process identification
number (PIN) greater than 255.
Specifying -highpin on means that the child process can run with a PIN greater
than 255. Specifying -highpin off means the child process must run with a PIN
between 0 and 254.
The default value is -highpin on, unless an off value for the Guardian process
attribute is inherited from osh.
Refer to the TACL Reference Manual for additional information about high and
low PINs.
-inspect on | -inspect off | -inspect saveabend
Indicates the Inspect mode to be used for the child process.
Specifying -inspect on causes the child process to enter the currently defined sym-
bolic debugger when the -debug option is specified or if a debug event occurs.
Specifying -inspect off causes the child process to enter the default debugger
when the -debug option is specified or if a debug event occurs.
Specifying -inspect saveabend causes creation of a saveabend file (process
snapshot file or core file) when the process terminates abnormally.
The default Inspect mode is the mode specified in the program file of the child
process.
Refer to the appropriate debugger manual for additional information about debug
events and debugger use.
-jobid 0 | -jobid -1
Controls the job ID to be assigned to the child process.
Specifying -jobid 0 prevents the child process from running as part of a batch job
(the osh process cannot function as a batch job ancestor, so no other value than -
jobid -1 is supported).
Specifying -jobid -1 causes the child process to inherit its job ID (if any) from
osh.
527188-007 Hewlett-Packard Company 6−95