Open System Services Shell and Utilities Reference Manual (G06.29+, H06.08+, J06.03+)

User Commands (g - j) initfilepriv(1)
NAME
initfilepriv - Sets file privileges for selected system files
SYNOPSIS
initfilepriv sysnn_path
FLAGS
Operands
sysnn_path Specifies the path to the system subvolume that contains the sys-
tem files that require file privileges (such as the Backup and
Restore 2 product files). Typically, this is the current system sub-
volume, usually specified as /G/system/sysnn, where nn indi-
cates the system installation that is currently running.
DESCRIPTION
The initfilepriv command sets the file privileges on selected system files. For example, it sets
the file privileges on the Backup and Restore 2 product such that, when started by a user with the
appropriate privilege, it can back up and restore files that are in restricted-access filesets.
This command is supported on systems running J06.11 or later J-series RVUs or H06.22 or later
H-series RVUs only. The Backup and Restore 2 product must also be installed on a system run-
ning J06.11 or later J-series RVUs or H06.22 or later H-series RVUs only.
Only Members of Safeguard SECURITY-PRV-ADMINISTRATOR (SEC-PRIV-ADMIN or
SPA) group are permitted to use this command.
For more information about restricted-access filesets and file privileges, see the Open System Ser-
vices Management and Operations Guide.
EXAMPLE
To set the file privileges for Backup and Restore 2 application files in the sys21 subvolume,
enter:
initfilepriv /G/system/sys21
RELATED INFORMATION
Commands: getfilepriv(1), setfilepriv(1).
Functions: setfilepriv(2).
STANDARDS CONFORMANCE
This command is an HP extension.
527188-021 Hewlett-Packard Company 4−57