Open System Services Shell and Utilities Reference Manual (G06.29+, H06.08+, J06.03+)

ManualsBrandsHP ManualsServerHP NonStop G-Series

921

922

923

924

925

926

927

928

929

930

portmap(8) OSS Shell and Utilities Reference Manual

enforced by HP software. The value used does not need to contain any speciﬁc

collection of letters or the digit n.

node Speciﬁes the Expand node name of the NonStop server node on which to run the

portmapper process.

If this value is omitted, the portmapper process is run on the local NonStop server

node.

n The value you specify depends on whether you use conventional TCP/IP or paral-

lel library TCP/IP.

• For conventional TCP/IP, by convention, this number matches the number

used in the process name of the TCP/IP server process that provides the

correct IP address.

This value is usually 0, corresponding to the assumed default TCP/IP pro-

cess name of $ZTC0.

• For parallel library TCP/IP, you must specify the fourth and ﬁfth charac-

ters of the process name for the TCPSAM process.

The correct number to specify depends on the IP address that the portmapper pro-

cess should be registered with. Refer to the NOTES section of this reference page

for a procedure that can help you choose a number based on the IP address

conﬁgured for a TCP/IP server process.

The process name used for the portmapper process is a convention and is not

enforced by HP software. The value used does not need to contain any speciﬁc

collection of letters or the digit n.

param Is one of the following options:

[ BACKUPCPU ] proce ssor

Speciﬁes the processor number in the range 0 through 15 of the

processor that should run the backup process of the portmapper

process pair. The value used should not specify the processor that

runs the primary portmapper process of the process pair.

The keyword BACKUPCPU can be omitted only if this is the

ﬁrst value for the param option speciﬁed in the command.

If this option is omitted, the portmapper process does not run as a

process pair.

TCPIP pname Speciﬁes the Guardian process name of the standard process that

provides access to the portmapper process.

If this option is omitted, the value speciﬁed in the

=TCPIPˆPROCESSˆNAME DEFINE is used.

If this option is speciﬁed, the value used must meet the same

requirements as those described for =TCPIPˆPROCESSˆNAME

DEFINE values.

If both this option and the DEFINE are omitted, the default name

for the TCP/IP server process is $ZTC0.

12−56 Hewlett-Packard Company 527188-021