Open System Services System Calls Reference Manual (G06.28+, H06.05+)

spt_sendx(2) OSS System Calls Reference Manual
[ENETDOWN]
The local interface used to reach the destination is down.
[ENETUNREACH]
No route to the network or host is present.
[ENOBUFS] Not enough buffer space was available to complete the call. A
retry at a later time might succeed.
[ENOMEM] Required memory resources were not available. A retry at a
later time might succeed.
[ENOTCONN] The socket either is not connected or has not had the peer socket
previously specified.
[ENOTSOCK] The socket parameter does not refer to a socket.
[EOPNOTSUPP]
The specified value for the flags parameter is not supported for
this socket type or protocol.
[EPIPE] One of the following conditions occurred:
— An attempt was made to send a message on a socket that
is shut down for writing.
— An attempt was made to send a message on a
connection-oriented socket and the peer socket is closed
or shut down for reading. The SIGPIPE signal is also
sent to the calling process.
[EWOULDBLOCK]
The socket’s file descriptor is marked nonblocking
(O_NONBLOCK is set) and the operation would block.
RELATED INFORMATION
Functions: connect(2), getsockopt(2), recv(2), recvfrom(2), recvmsg(2), select(2), send(2),
sendmsg(2), sendto(2), setsockopt(2), shutdown(2), socket(2), spt_recvx(2),
spt_recvfromx(2), spt_recvmsgx(2), spt_send(2), spt_sendtox(2), spt_sendmsgx(2).
STANDARDS CONFORMANCE
This function is an extension to the UNIX 98 specification. Interfaces documented on this refer-
ence page conform to the following industry standards:
— IEEE Std 1003.1c-1995, POSIX System Application Program Interface
The use of the header file spthread.h is an HP exception to the POSIX standard.
7−308 Hewlett-Packard Company 527186-007