OSF DCE Administration Guide--Core Components

OSF DCE Administration Guide—Core Components

Note: If you are reconﬁguring a node that previously ran a DTS clerk so

that it runs a DTS server, you need to perform extra steps. You must

create a principal account for the new server in the DCE Security

Service registry, and you must add the server’s name to the existing

DTS server group (dts-entity). Otherwise, DTS clerks will not be

able to ﬁnd the newly created server. For instructions on creating a

principal account, see Chapter 31 of this guide. For instructions on

adding a principal name to a group, refer to Chapter 30.

3. Set any clerk or server attribute values as needed by using the DCE control

program’s dts modify command. The following section provides instructions for

modifying DTS clerk and server attributes.

25.5 Modifying Clerk and Server Attributes

Many management tasks involve modifying the attributes of DTS clerks and DTS

servers. The DCE control program has several commands for displaying and changing

the attributes of these entities.

To display the attribute values of a DTS clerk or DTS server, you use the dts show

command. (The dts show command can also be used to view the values of DTS entity

counters; however, you cannot modify counter values.

For example, to display the attributes values for all the clients and servers on the local

node, enter the following command:

25 − 8 Tandem Computers Incorporated 124243