OSF DCE Administration Guide--Core Components

OSF DCE Administration Guide—Core Components
• If you anticipate a simultaneous address change, while the master and slave are still
communicating, use the dcecp set command to bind to the master and then the dcecp
registry delete command to delete the slave replica.
• If secd is running at the master and slave sites, but the master and slave are not
communicating, first use the dcecp set command to bind to the slave and then the
registry delete -only command to destroy the slave. Then use dcecp set to bind to
the master and the registry delete -force command to remove the replica list entry
for the slave.
• If secd is not running at the slave site or if you are unable to bind to the slave site, use
the procedure for recreating a replica described in Chapter 40.
37 − 4 Tandem Computers Incorporated 124243