OSF DCE Administration Guide--Introduction

Configuring DCE
f. Type a number for the aggregate ID and press <RETURN>. The aggregate
ID must be unique on the machine being configured.
After you complete the steps listed in "Exporting the Native File System" or
"Exporting the Episode File System," the dce_config script exports the chosen
file system and displays instructions on where to find information about
exporting additional file systems by displaying:
S:****** Exporting device_name through DFS...
If you wish to export additional aggregates, do so after
completing this script by using the appropriate DFS
administration commands described in the DFS Admin Guide.
Press <RETURN> to continue, CTRL-C to exit:
7. Press <RETURN>.
The dce_config script displays:
S:****** Starting fxd...
fx: FX server starts listening...
and returns the Additional Server Configuration menu.
8.8.4.4 Configuring a DFS Fileset Location Database
Each cell that uses DFS requires at least one Fileset Location Database (FLDB) Server
machine. Configure this machine immediately after configuring the DFS System
Control machine.
To configure a Fileset Location Database machine, perform the following steps:
1. Type 6 on the Additional Server Configuration menu and press <RETURN>.
The dce_config script displays the following message:
S:****** Configuring DFS Fileset Location Database Server...
and then prompts:
Enter Cell Administrator’s principal name: (cell_admin)
2. Type the name of the principal who was defined to be the initial privileged user
of the registry database during the configuration of the master Security server
and press <RETURN>.
The dce_config script prompts:
Enter password:
3. Type the password for the initial privileged user’s account and press
<RETURN>. Note that this password is not displayed as you type it.
124244 Tandem Computers Incorporated 8− 21