OSF DCE Administration Guide--Introduction

Configuring DCE
1. Native File System (e.g. UFS, JFS)
2. Episode File System (LFS)
selection:
Your next steps depend on whether you want to export the native file system or
the Episode file system. If you are exporting the native file system, go to the
subsection titled "Exporting the Native File System." If you are exporting the
Episode file system, go to the subsection titled "Exporting the Episode File
System."
Exporting the Native File System
To export the native file system, perform the following steps.
a. Type 1 and press <RETURN>.
The dce_config script prompts:
Enter the aggregate name (/export):
Note: The information in parentheses in the previous prompt is not
the default value, but only an example of a value to be
entered.
b. Type the aggregate name and press <RETURN>.
You must specify the aggregate name as a mounted file system name, not
as a physical device name. For example, to use the device /dev/rz3c,
which is mounted as /var, specify /var as the aggregate name.
The dce_config script prompts:
Enter the aggregate ID (1):
c. Type the aggregate ID and press <RETURN>.
Exporting the Episode File System
To export the Episode File System, perform the following steps:
a. Type 2 and press <RETURN>.
The dce_config script prompts:
Enter the device name for the aggregate to be exported (i.e. /dev/lvXX):
Note: The information in parentheses in the previous prompt is not
the default value, but only an example of a value to be
entered.
b. Type the pathname of the device on which the selected file system is
stored and press <RETURN>.
The dce_config script prompts:
Enter the LFS fileset name (lfs_set):
124244 Tandem Computers Incorporated 8− 23