OSF DCE Administration Guide--Introduction

OSF DCE Administration Guide—Introduction
____________________________________________________________
Variable Value
____________________________________________________________
highest UNIX ID currently used on
the machine being configured,
incremented by the value of
UID_GAP. Although there is no
restriction that the value of
LOW_UID must be higher than the
machine’s highest UNIX ID, if you
supply a LOW_UID that is less
than or equal to the highest
currently used UNIX ID,
dce_config issues a warning
message and prompts the user to
reenter LOW_UID. Used in master
Security server configuration.
____________________________________________________________
An indication of whether or not to
configure the node with multiple
LAN capabilities: y indicates
configure with multiple LAN
capabilities, n indicates do not.
Used in CDS configuration
MULTIPLE_LAN
____________________________________________________________
The name of the host on which the
NTP time provider server is
running. Used in DTS Time
Provider configuration.
NTP_HOST
____________________________________________________________
The default pathname to the
Password Management server,
which is
$DCELOCAL/bin/pwd_strength.
Used in Password Management
server configuration.
PWD_MGMT_SVR
____________________________________________________________
The default options for the
Password Management server
(pwd_strength). The value of the
variable is set to -v (verbose) at
server configuration.
PWD_MGMT_SVR_OPTIONS
____________________________________________________________
An indication of whether or not to
remove all remnants of previous
DCE installations before
performing the new install: y
indicates remove all remnants; n
indicates do not. Be aware that if
you set this variable to
automatically remove all installed
components each time you install
any component, and you must
REMOVE_PREV_INSTALL
____________________________________________________________
10 − 14 Tandem Computers Incorporated 124244