OSF DCE Administration Guide--Introduction

OSF DCE Administration Guide—Introduction
____________________________________________________________
Variable Value
____________________________________________________________
Security server (the name specified
in the SEC_SERVER variable).
____________________________________________________________
The number of seconds a client
system clock can differ from the
Security server system clock before
either the user prompted to
synchronize clocks or clocks are
synchronized automatically. The
default is 120 seconds. Both the
Security service and the CDS
service require that be no more
than a 5-minute difference between
the clocks on any two nodes in a
cell. For a DFS File Location
Database Server, the variable
should not be set to less than 90
seconds.
TOLERANCE_SEC
____________________________________________________________
The increment above highest
currently used UID at which the
Security service will start assigning
automatically generated UIDs.
The value of this variable is used
with the LOW_UID variable to set
the starting point for UIDs
automatically assigned by the
Security server. Default is 100.
Used in Security server
configuration.
UID_GAP
____________________________________________________________
The name of the node to be
unconfigured. Used with the
unconfigure option.
UNCONFIG_HOST_PRESET
____________________________________________________________
10.2.2 The dfs_config Environment Variables
Many variables specific to DFS are set explicitly in the dfs_config component script. You
can use these variables to supply information to dfs_config instead of typing the
information in in response to prompts.
Table 10-2 shows the DFS values that are set in the dfs_config component script. In the
table, the term default refers to the setting assigned to the environment variable by OSF.
10 − 16 Tandem Computers Incorporated 124244