OSI PICS Manual

ISO 8073 for OSI/TS
Tandem OSI PICS Manual–135046
5-12
D.11.2 Parameter Values for CR TPDU (C1:: or C2::
or C3:: or C4:: or C4L::)
D.11.1.2 NCM TPDU (SN3::)
What are the allowed values of the following parameters for an NCM TPDU.
D.11.1.3 DIAG TPDU (SN5::)
What are the allowed values of the following parameters for a DIAG TPDU.
D.11.2 Parameter Values for CR TPDU (C1:: or C2:: or C3:: or C4:: or
C4L::)
If the additional options selection parameter is issued in a CR TPDU, it is mandatory
that:
If the preferred class in the CR is 2, 3 or 4:
D.11.3 Supported Parameters for Class 0 TPDUs (C0::)
The following parameters are optional if a CR TPDU is issued with preferred class 0.
Index Supported Parameters
References
Add. 1
Values
Allowed
Values
Supported
IC1 NC-reference 8.4.3 b) No
IC2 NC-type 8.4.3 c) New, My, Yours No
IC3 NC-preference 8.4.3 d) Highest, Medium, Lowest No
IC4 NC-collision 8.3.4 e) Resolution No
IC5 NC-recovery 8.3.4 f) Do not, Do No
IC6 NC-assignment right 8.3.4 g) Receiver, Sender, All No
Index Supported Parameters
References
Add. 1
Values
Allowed
Values
Supported
IDI Code 8.5.3 b) Collision detection resolution,
NC no longer needed, NC
temporarily not accepted, NC
not accepted on long-term
No
Index Reference
ICR1 Bits 8 to 5 shall be set to zero 13.3.4 f)
Index Reference Status Support
ICR2 Is class 0 always offered as an alternative class? 14.4 O
CCT:M
Ye s
Ye s
Index Supported Parameters References Status Support
I0CR6 Called TSAP ID 13.3.4 a) O Yes
I0CR7 Calling TSAP ID 13.3.4 a) O Yes
I0CR8 TPDU size 13.3.4 b) O Yes