OSI/AS Configuration and Management Manual

OSI/AS Configuration and Management Manual—424119-001
A-1
A
Examples of Configuration Command
Files
This appendix contains examples of command files of Guardian and SCF commands to
set up particular subsystem configurations. Since each of these examples contains a
mixture of SCF and non-SCF commands, use the OBEY command to invoke the
appropriate file. The six example configurations are as follows:
•
OSI/AS Over an X.25 Network on page A-2
•
OSI/AS Over an X.25 Network, Using SNDCF on page A-5
•
OSI/AS Over a LAN on page A-7
•
OSI/AS Over a LAN, Using ES-IS Routing Exchange Protocol on page A-9
•
OSI/AS Over a LAN, Using IP null on page A-11
•
OSI/AS, Large Application, Over an X.25 Network on page A-13
These examples use the following process and filenames:
To help you locate these names in the example command files, they are shown in
uppercase.
Process or Filename Description
$OSIM OSI manager process name
$DISK1 Swap volume
TAPS1 TAPS internal name
$TAPS1 TAPS process name
TSP1 TSP internal name
$TSP1 TSP process name
LAM1 TLAM + network internal name *
$LAM1 TLAM + network process name *
X251 X25AM network internal name
$X251 X25AM network process name
ZOSIDB OSI MIB name
ZOSIDB0 OSI alternate MIB name
$SYSTEM.SYS01.OSIMGR OSI manager process object file
$SYSTEM.SYS01.TAPSOBJ TAPS process object file
$SYSTEM.SYS01.TSPOBJ TSP process object file
$SYSTEM.SYSTEM.SCF SCF object file
* PAM replaces TLAM for G06 and above releases.