OSI/AS Management Programming Manual

ADD PROCESS Command
Commands and Responses
5–28 056785 Tandem Computers Incorporated
ZPRIM-CPU
is the number of the CPU in which the primary process (of the new process
pair) will run. The range of values is 0 through 15. The default value is the
number of the CPU in which the primary OSI manager process is running.
ZBKUP-CPU
is the number of the CPU in which the backup process (of the new process
pair) will run. The range of values is 0 through 15. The default value is the
number of the CPU in which the backup OSI manager process is running.
ZPRI
is the Guardian 90 process priority of the new process. The range of values is
1 through 199. The default value is the same priority as the OSI manager
process.
ZCODEFILE
is the fully qualified Guardian 90 file name of the code file that is run to create
the new process.
ZSWAP
is the disk volume to be used as a swap disk when the OSI manager starts the
process.
ZMAX-CONNS
specifies the maximum number of concurrent connections allowed within a TAPS
process and can also allow large-sized messages to be divided into smaller
segments when sending messages to TSP processes. Smaller values allow the
TAPS process to send messages in large-sized segments, resulting in greater
thruput. Larger values allow the TAPS process to send messages in smaller
segments.
Note You may specify larger values (up to 1024) to a TSP process directly by issuing the SCF/TS ALTER
PROCESS command. See the SCF Reference Manual for OSI/TS.
ZHIGH-PIN
This field determines whether the process indicated will be started by the
specified OSI manager process with a high PIN or a low PIN. The possible
values are:
ZSPI-VAL-TRUE
ZSPI-VAL-FALSE