OSI/AS Management Programming Manual

ADD PROFILE Command
Commands and Responses
5–36 056785 Tandem Computers Incorporated
ZX25CUG-TYPE
specifies the type of closed user group (CUG) facility. This attribute is used
only for X.25 networks. The possible values are:
Value Meaning
ZOSI-VAL-X25CUG-TYPE-BASIC Basic CUG format
ZOSI-VAL-X25CUG-TYPE-EXT Extended CUG format
ZOSI-VAL-X25CUG-TYPE-BASICOA Basic CUG format with outgoing access
ZOSI-VAL-X25CUG-TYPE-EXTOA Extended CUG format with outgoing access
If no value is provided for X25CUG, X25CUGTYPE will default to ZOSI-VAL-
X25CUG-TYPE-BASIC. If X25CUG is 0 to 99, X25CUGTYPE can be any of the
four values, and will default to ZOSI-VAL-X25CUG-TYPE-BASIC. If X25CUG
is 100 to 9999, X25CUGTYPE must be ZOSI-VAL-X25CUG-TYPE-EXT or
ZOSI-VAL-X25CUG-TYPE-EXTOA, and will default to ZOSI-VAL-X25CUG-
TYPE-EXT. If you do not provide a value, the value of the CUGTYPE attribute
in X25AM is used.
ZX25BCUG
specifies the bilateral closed user group ID sent in every call-request packet.
This attribute is used only for X.25 networks. The value is an integer from 0
through 9999. No default value is provided. If you do not provide a value,
the value of the BCUG attribute in X25AM is used.
ZX25RPOA
specifies the Recognized Private Operating Agency (RPOA) transit network(s)
in the facility field of a call-request packet. This attribute is used only for X.25
networks. An RPOA transit network is indicated by the Data Network
Identification Code (DNIC), which is an integer with the range 0 through 9999.
There can be 0 through 7 DNICs in the X25RPOA integer list. To clear a
previously specified RPOA, assign the value ZOSI-VAL-RPOA-RESET.
ZX25RPOA-DNIC-CNT
specifies the number of DNICs in the ZX25RPOA integer list. The value is an
integer from 0 through 7.
ZX25TRANSIT-DELAY
specifies the transit delay in the facility field of a call-request packet. This
attribute is used only for X.25 networks. The value is in timestamp format
between 0 through 6553 hundredths of a second). The Layer 3 service
ZX25TRANSIT-DELAY value establishes a default value if this attribute is not
given. If the Layer 3 service is also not present, no value is provided.
To clear a previously specified TRANSIT-DELAY, assign the value ZOSI-VAL-
TRANSIT-DELAY-RESET.