OSI/AS Management Programming Manual

ADD PROFILE Command
Commands and Responses
5–40 056785 Tandem Computers Incorporated
attempted; if it is set to ZSPI-VAL-FALSE, multiplexing is not attempted. The
default value is ZSPI-VAL-FALSE.
Multiplexing requires that two or more transport connections have the same
local and remote NSAP addresses; have ZCLASS set to 2, 3, or 4; and have
ZMULTIPLEX set to ZSPI-VAL-TRUE. If these conditions are met, the
maximum number of outgoing transport connections that can be multiplexed
is determined by the Layer 3 SERVICE attribute ZX25NCON-MULTIPLEX.
ZREXMIT-TIMEOUT
is the maximum amount of time that the transport entity should wait for an
acknowledgment before resending the TPDU. This field applies only to
protocol class 4 communication. The waiting time is expressed in hundredths
of a second (0.01 seconds per increment). The values range from 100 (1
second) through 3000 (30 seconds). The default value is 1000 (10 seconds).
ZREF-TIMEOUT
is the maximum amount of time that the transport entity should wait before
reusing any reference or sequence number. The waiting time is expressed in
hundredths of a second (0.01 seconds per increment). The values range from
300 (3 seconds) through 18000 (180 seconds). The default value is 3000 (30
seconds).
ZMAX-REXMIT
is the maximum number of times unacknowledged TPDUs are retransmitted
before the connection is terminated. This field applies only to protocol class 4
communication. The values range from 1 through 8. The default value is 3.
ZINACTV-TIMEOUT
is the maximum amount of time that the transport entity should wait without
receiving any TPDUs before terminating the connection. This field applies
only to protocol class 4 communication. The waiting time is expressed in
hundredths of a second (0.01 seconds per increment). The values range from
100 (1 second) through 50000 (500 seconds). The default value is 3000 (30
seconds).
ZWIN-TIMEOUT
is the maximum amount of time that the transport entity should wait before
retransmitting up-to-date window information. This field applies only to
protocol class 4 communication. The waiting time is expressed in hundredths
of a second (0.01 seconds per increment). The values range from 100 (1
second) through 25000 (250 seconds). The default value is 1000 (10 seconds).
ZTTR-TIMEOUT
is the maximum amount of time that the initiating transport entity should wait
for reassignments to be completed before releasing the connection. (A