OSI/AS Management Programming Manual

ADD PROFILE Command
Commands and Responses
056785 Tandem Computers Incorporated 5–41
reassignment is attempted when the network connection has failed. Request
for reassignment is indicated by a nonzero value in the CR-TPDU. No
reassignment attempt is made if the CR-TPDU contains a value of 0.)
This field applies only to protocol class 1 or 3 communication. The waiting
time is expressed in hundredths of a second (0.01 seconds per increment). The
values range from 0 (0 seconds) through 18000 (180 seconds). The default
value is 9000 (90 seconds).
ZTWR-TIMEOUT
is the maximum amount of time that the responding transport entity should
wait for reassignments to be completed before releasing the connection. (A
reassignment is attempted when the network connection has failed. Request
for reassignment is indicated by a nonzero value in the CR-TPDU. No
reassignment attempt is made if the CR-TPDU contains a value of 0.)
This field applies only to protocol class 1 or 3 communication. The waiting
time is expressed in hundredths of a second (0.01 seconds per increment). The
values range from 0 (0 seconds) through 18000 (180 seconds). The default
value is 12000 (120 seconds).
ZCONN-TIMEOUT
is the maximum amount of time that the transport entity should wait for a
response to a CR-TPDU before releasing the connection. The waiting time is
expressed in hundredths of a second (0.01 seconds per increment). The values
range from 300 (3 seconds) through 18000 (180 seconds). The default value is
12000 (120 seconds).
ZDISCONN-TIMEOUT
is the amount of time that the transport entity should wait for a response to a
disconnect request transport protocol data unit (DR-TPDU) before releasing
the connection. The waiting time is expressed in hundredths of a second (0.01
seconds per increment). The values range from 300 (3 seconds) through 18000
(180 seconds). The default value is 12000 (120 seconds).
ZEXPEDITED
controls Transport Layer expedited data transfer. This field applies only to
protocol class 2, 3, or 4 communication. If this field is set to ZSPI-VAL-TRUE,
expedited data transfer is supported; if it is set to ZSPI-VAL-FALSE, expedited
data transfer is not supported. The default value is ZSPI-VAL-FALSE.