OSI/AS Management Programming Manual

INFO SERVICE Command
Commands and Responses
5–144 056785 Tandem Computers Incorporated
ZIP-X25-SNDCF
controls the the subnetwork dependent convergence facility (SNDCF). This
parameter is meaningful only if the Transport Layer protocol uses the OSI
internet protocol (IP) to communicate, via the SNDCF, with an X.25 network.
If this field is set to ZSPI-VAL-TRUE, the SNDCF is enabled; if it is set to ZSPI-
VAL-FALSE, the SNDCF is disabled. See “Operational Notes” for further
information.
ZESIS-ENABLE
controls the end system to intermediate system (ES-IS) protocol. If this field is
set to ZSPI-VAL-TRUE, the ES-IS protocol is enabled; if it is set to ZSPI-VAL-
FALSE, the ES-IS protocol is disabled. See “Operational Notes” for further
information.
ZESIS-ES-CONF-TIME
is the length of the time interval at which the protocol must report its
configuration to the subnetwork. This field is applicable only if ZESIS-
ENABLE is set to ZSPI-VAL-TRUE. The interval is expressed in hundredths
of a second (0.01 seconds per increment), rounded down to the nearest second.
The values range from 100 (1 second) through 65500 (655 seconds).
ZESIS-ES-GROUP-MAC-ADDR
is the media access control (MAC) station group address used by all the OSI
end systems in the network. This field is applicable only if ZESIS-ENABLE is
set to ZSPI-VAL-TRUE. The address is expressed as a string of up to 12
hexadecimal digits.
ZESIS-IS-GROUP-MAC-ADDR
is the MAC station group address used by all the OSI intermediate systems in
the network. This field is applicable only if ZESIS-ENABLE is set to ZSPI-
VAL-TRUE. The address is expressed as a string of up to 12 hexadecimal
digits.
ZESIS-NOTIFY-IS
controls whether the ES-IS protocol reports its configuration whenever it
determines that a new intermediate system is first available. This field is
applicable only if ZESIS-ENABLE is set to ZSPI-VAL-TRUE. If ZESIS-
NOTIFY-IS is set to ZSPI-VAL-TRUE, the configuration is reported; if it is set
to ZSPI-VAL-FALSE, the configuration is not reported.
ZESIS-XSUM
controls whether the ES-IS protocol includes a checksum in outgoing transport
protocol data units (TPDUs). This field is applicable only if ZESIS-ENABLE is