OSI/AS Programming Manual

APS_ASSOC_GETPARAM_
APS Procedure Calls
3–46 056783 Tandem Computers Incorporated
release-result output
INT .EXT:ref:1
indicates the result of your connect release attempt. This parameter is available
only after you have received a release confirm primitive. This parameter can have
the following possible values:
ZAPS-VAL-RLS-NOVALUE
ZAPS-VAL-RLS-ACCEPT
ZAPS-VAL-RLS-NOTACCEPT
See ZAPS-VAL-RLS-xxx in Appendix A for the meanings of these values.
abort-reason output
INT .EXT:ref:1
indicates the reason the service provider aborted the connection. This parameter is
available only after you have received a provider abort indication primitive. See
ZAPS-VAL-ABORT-xxx in Appendix A. Note that if the abort came from the
remote service provider, a value other than one of the ZAPS-VAL-ABORT-xxx
values may be returned. This occurs if the abort reason generated by the remote
provider does not correspond to any of the abort reasons defined by OSI/AS. For
more information about the abort reason, see the session protocol standard, ISO
8327.
mode output
INT: .EXT:ref:1
indicates the mode of operation for your connection. The possible values are
ZAPS-VAL-MODE-NORMAL and ZAPS-VAL-MODE-X410-1984. This parameter
applies only to presentation and ACSE connections; it is available after a connect
request or indication.
pres-context-list output
INT .EXT:ref:(ZAPS-DDL-PRES-CNTXT-LIST)
indicates the presentation context definition list for your connection. This
parameter applies only to presentation and ACSE connections. It is available after
a connect indication if it was specified in the connect request; for ACSE, it will
always be available. For more information about this parameter, see ZAPS-DDL-
PRES-CNTXT-LIST in Appendix A and “Encoding ACSE and Presentation User
Data” in Section 2.