OSI/AS Programming Manual

APS_ASSOC_GETPARAM_
APS Procedure Calls
056783 Tandem Computers Incorporated 3–49
acse-remote-invocation-ids output
INT .EXT:ref:(ZAPS-DDL-INVOCATION-IDS)
is the ACSE application entity and application process invocation identifiers of the
calling entity for a connect indication, or of the responding entity for a connect
confirm. This parameter applies only to ACSE connections. It is available for an
indication if it was specified in the connect request; it is available for a confirm if it
was specified in the connect response. For more information about this parameter,
see ZAPS-DDL-INVOCATION-IDS in Appendix A.
acse-result-source output
INT .EXT:ref:1
is the ACSE result source that identifies the source of the connect-result , and
the source of the acse-diagnostic if the acse-diagnostic is also present.
This parameter applies only to ACSE connections and is always available after a
connect confirm. For the possible values of this parameter, see ZAPS-VAL-RSLT-
SRC-xxx in Appendix A.
acse-diagnostic output
INT .EXT:ref:1
is the ACSE diagnostic for a connect confirm. It is available if the connect-
result parameter is ZAPS-VAL-CON-REJECT-PERM or ZAPS-VAL-CON-
REJECT-TRANS, and if it was specified in the connect response. This parameter
applies only to ACSE connections. For the possible values of this parameter, see
ZAPS-VAL-DIAG-xxx in Appendix A.
acse-release-reason output
INT .EXT:ref:1
is the release reason for an ACSE release indication or confirm. This parameter
applies only to ACSE connections. For the possible values of this parameter, see
ZAPS-VAL-RLS-RSN-xxx in Appendix A.
acse-abort-source output
INT .EXT:ref:1
is the ACSE user abort source for a user abort indication. This parameter applies
only to ACSE connections and is always available after a user abort indication.
The possible values are ZAPS-VAL-ABORT-SRC-ACSE-PROV and ZAPS-VAL-
ABORT-SRC-ACSE-USER.