OSI/AS Programming Manual

About This Manual
xviii 056783 Tandem Computers Incorporated
Other Tandem OSI Manuals In addition to the prerequisite manuals shown in Figure 0-1, you may need to be
familiar with some of the other manuals in the Tandem OSI/AS manual set. These
manuals describe various aspects of the management of OSI/AS subsystems.
The Tandem OSI/AS Configuration and Management Manual describes how to configure
and manage the OSI/AS subsystem. It is intended for system managers and
operators.
The SCF Reference Manual for Tandem OSI/AS describes the SCF commands used to
configure and manage the OSI/AS subsystem.
The Tandem OSI/AS Management Programming Manual describes the management
programming interface to the OSI/AS subsystem. This interface enables you to write a
program to perform configuration and management of OSI/AS.
The Tandem OSI/TS Manual describes how to install and manage the OSI/TS
subsystem, and also describes the programmatic interface to the OSI/TS subsystem.
If you are using OSI/AS, your system manager or operator will need to install the
OSI/TS subsystem and perform some management functions using the management
interface to OSI/TS. Users of OSI/AS will probably not need to use the OSI/TS
programmatic interface.
The SCF Reference Manual for Tandem OSI/TS describes the SCF commands used to
configure and manage the OSI/TS subsystem.
The Tandem OSI/TS Management Programming Manual describes the management
programming interfaces to the OSI/TS subsystem. This interface enables you to write
a program to perform configuration and management of OSI/TS.