OSI/AS SCF Reference Manual

OSI/AS SCF Commands
OSI/AS SCF Reference Manual—424121-001
2-88
ALTER SERVICE #L3 Command
X25PVC
specifies the channel number of the permanent virtual circuit (PVC) with which the
X25AM subdevice to be created is bound. This attribute is used only for X.25
networks.
If a TSP subdevice is configured to use X25PVC, all other subdevices with the same
X25PVC must use transport protocol class 2, 3 or 4. They will be multiplexed to use
the same X25PVC and no additional X25AM subdevices are created for either
connect or attach requests. The MULTIPLEX attribute will be ignored. If the
transport protocol class used is 0 or 1 (non-multiplexing classes), then the
subdevices must be configured with different X25PVCs.
The value of X25PVC must be compatible with the values of the attributes
PVCRANGE and SVCRANGE (see the ALTER LINE command in the X25AM
product). See the SCF Reference Manual for X25AM for information about how to
set up an X.25 line as a PVC line.
RESET returns this attribute to the value of the PVC attribute in X25AM.
X25REMOTENET
specifies the addressing conventions to be used when building the called address in
a call-request packet. This attribute is used only for X.25 networks.
X25REVERSECHG
specifies whether an outgoing call request asks the recipient to pay the charges. ON
indicates that the recipient is requested to pay the charges. OFF indicates that the
recipient is not requested to pay the charges. This attribute is used only for X.25.
Value: 1 through 4095 for non-TRANSPAC networks; 0 through
4095 for TRANSPAC networks.
OSIMGR Default: Defaults to the value of the PVC attribute in the X25AM
subsystem.
Value: DATANET | DATAPAC | DATEXP | DDXP |
PSS | TELENET | TRANSPAC | TYMNET |
UNINET | X25NP | X25SA | X25UD | X25XA
OSIMGR Default: Defaults to the value of the NETID attribute in the X25AM
subsystem.
Value: ON | OFF
OSIMGR Default: OFF