OSI/AS SCF Reference Manual

OSI/AS SCF Commands
OSI/AS SCF Reference Manual—424121-001
2-109
Examples of the ALTER Command
SERVICE Object
•
The ALTER SERVICE command can only be used for the OSI manager process.
•
For ALTER SERVICE commands, the changed values for any changed attributes
only apply to new connections and new profiles. Existing connections and profiles
are not affected.
•
The transport protocol class and alternate transport protocol class are determined by
the ALTCLASS, CLASS, MULTIPLEX, and NETTYPE attributes. See the
PROFILE Object discussion above.
SUBSYS Object
•
The OSI manager process must be in the SUSPENDED state before the SUBSYS
attributes can be altered.
Examples of the ALTER Command
The examples are designed to show correct ways of specifying command syntax.
ENTRY Object
ALTER ENTRY $OSIM.#TSEL.0002, L5SERVER $OSIM.#TAPS.TAPS2
ALTER ENTRY $OSIM.#NSAP.9A0002, L4SERVER $OSIM.#TSP.TSP2 &
, L3PROFILE $OSIM.#L3.L3PROF
ALTER ENTRY $OSIM.#SNPA.123456, L3SERVER $OSIM.#NSP.NSP2
ALTER ENTRY $OSIM.#APPL.0101, L5SERVER $OSIM.#TAPS.TAP1 &
, L4SERVER $OSIM.#TSP.TSP1, NSAP RESET, TSEL 60
PROCESS Object
ALTER PROCESS $OSIM.#TSP.TSP1, PRIORITY 170
ALTER PROCESS $MGR.#TAPS.TAP1 , HIGHPIN OFF, SWAP $ABC
PROFILE Object
ALTER PROFILE $OSIM.#L3.PROF1, X25ACCEPTCHG ON
ALTER PROFILE $OSIM.#L4.PROF2, CLASS 4, SENDSECURITY RESET
ALTER PROFILE $OSIM.#L5.PROF3, VSN1 ON, VSN2 ON