OSI/AS SCF Reference Manual

About This Manual
OSI/AS SCF Reference Manual—424121-001
xvii
OSI/AS Manual Set
OSI/AS Manual Set
The following list describes the contents of the OSI/AS manual set:
•
The OSI/AS SCF Reference Manual (this manual) describes the Subsystem Control
Facility (SCF) commands that are used to configure and control the OSI/AS
subsystem. This manual also describes the SCF commands used to display OSI/AS
configuration and status information and the OSI/AS subsystem-specific PTrace
commands used to format and display trace records.
•
The OSI/AS Configuration and Management Manual describes how to install,
configure, and manage Compaq OSI/AS. This manual also includes information on
monitoring and adjusting OSI/AS to optimize performance along with information
on diagnosing and fixing problems.
•
The OSI/AS and OSI/TS Supplement (Includes RFC-1006 Support) supplements the
C30.08/D10 editions of the seven-manual set for OSI/AS and OSI/TS. It describes
RFC-1006 support and other general changes to the manuals.
•
The OSI/AS Management Programming Manual describes the Distributed Systems
Management (DSM) programmatic interfaces (SPI-format commands, responses,
and event messages) to the Compaq OSI/AS subsystem. It is intended for
programmers writing management applications that communicate with OSI/AS.
•
The OSI/AS Programming Manual shows programmers how to use the OSI Session
Layer, Presentation Layer, and ACSE procedural interface provided by the Compaq
OSI/AS subsystem. This interface allows applications to communicate in the OSI
environment.
•
The Operator Messages Manual describes system messages and provides an
explanation of the cause, a discussion of the effect on the system, and suggestions
for corrective action. Refer to this manual for descriptions of the operator messages
generated by Compaq OSI/AS.
Appendix D, OSI/AS SCF Attribute Name
Changes
Some attribute names have been changed to
improve product usability. All changes
maintain backward compatibility: existing
programs or command files will still work
with the original names. This appendix lists
the terms that have changed.
Appendix E, OSI/AS SCF Command
Support
This appendix identifies the SCF commands
that can be issued to the OSI/AS subsystem
and the commands that are not supported.
Glossary The glossary defines terms used in this and
other OSI manuals.
Table i. Manual Contents (page 2 of 2)
Section or Appendix Contents