OSI/AS SCF Reference Manual

OSI/AS Trace Facility
OSI/AS SCF Reference Manual—424121-001
3-20
SELECT Command
L5
specifies formatting of all L5 trace information. This includes the following trace
records:
L5 USER—L5 Event
L5 USER—L5 Continuation Event
L5 USER—L5 Abort Continuation Event
L5 USER—L5 Reply
L5 USER—L5 Request
L5 USER—L5 First Request
L5 USER—L5 Multi Mid Request
L5 USER—L5 Multi Last Request
L5 USER—L5 Multi Abort Request
L5 PROV—L5 Post Transport Read
L5 PROV—L5 Issue Read
L5 PROV—L5 Issue Transport Connect
L5 PROV—L5 Issue Transport Attach
L5 PROV—L5 Issue Writeread
L5 PROV—L5 Issue Transport Disconnect
L5 PROV—L5 Issue Write
L5 PROV—L5 Issue Write Expedited
L5 PROV—L5 I/O Completion
L5 PROV—L5 Send TSDU
L5 PROV—L5 Start Timer
L5 PROV—L5 Cancel Timer
L5—L5 Discard Session Resources
L5—L5 Error Report
L5 SM—L5 State Machine
Considerations for the SELECT Command
The considerations contain information about command use that should be read before
studying the command syntax in too much detail.
•
If no SELECT command is entered, the default is ALL.
•
If SELECT is specified with no mask or keywords, ALL is assumed.
•
The RESET and FROM commands reset the mask to ALL.
•
The “PTrace Select key” in the ENV command display shows the selected
enumerated values from the SELECT command. If you specified the trace file
(through the FROM command) and the subsystem used to create the trace file uses
keywords, then the “PTrace Select key” will show the keyword. If you did not
specify the trace file (through the FROM command), then the “PTrace Select key”
shows the enumerated value.
•
The SELECT command accepts all valid keywords including those that translate
into bit masks; however, the confirmation text displays the 32-bit mask value only if
that value is nonzero.