OSI/AS SCF Reference Manual

OSI/AS SCF Commands
OSI/AS SCF Reference Manual—424121-001
2-32
ADD PROCESS Command
L4PROFILE
identifies the name of the Layer 4 profile which might be used when configuring a
TSP subdevice.
L5PROFILE
identifies the name of a Layer 5 profile which might be used when configuring a
TAPS subdevice.
L5SERVER
defines the name of the TAPS process which might service connections for this
TSEL. This attribute is used only for local entry names.
ADD PROCESS Command
An attribute-spec for the ADD PROCESS command is one of the following
attribute name and value combinations:
Value: A Layer 4 profile name in the following format:
$osi-mgr-name.#L4.profile-name
Default: No default value is provided.
Value: A Layer 5 profile name in the following format:
$osi-mgr-name.#L5.profile-name
Default: No default value is provided.
Value: A TAPS process name in the following format:
$osi-mgr-name.#TAPS.internal-name
Default: No default value is provided.
[ BACKUPCPU integer ]
[ CODEFILE filename ]
[ HIGHPIN { ON | OFF } ]
[ MAXCONNECTIONS integer ]
{ NAME guardian-process-name }
[ PRIMARYCPU integer ]
[ PRIORITY integer ]
[ SWAP disk-volume ]
Note. The values specified (or the default values) for the attributes CODEFILE, NAME, and
SWAP must reside on the same node.