OSI/AS SCF Reference Manual

OSI/AS SCF Commands
OSI/AS SCF Reference Manual—424121-001
2-54
Considerations for the ADD Command
PROCESS Object
For the ADD PROCESS command, NAME is the only attribute that is used for NSP
processes all other attributes are ignored.
Both OSI/AS and OSI/TS support the MAXCONNECTIONS attribute; however, larger
values can be specified (up to 1024) to a TSP process directly by issuing the SCF/TS
ALTER PROCESS command. See the OSI/TS SCF Reference Manual.
PROFILE Object
At the time profiles are added, any protocol-related attribute values that are not supplied
for the profile entry are obtained from the corresponding service entry; this resulting
composite profile is what is registered in the MIB. At connection establishment time,
any missing values in the composite profile may be defaulted to a corresponding value
by the underlying subsystem (X25AM, TCP/IP, or TLAM for D-series releases or PAM
for G06 and above releases).
The transport protocol class and alternate transport protocol class are determined by the
ALTCLASS, CLASS, MULTIPLEX, and NETTYPE attributes. The following table
defines the valid combinations of values for these attributes.
ALTCLASS CLASS MULTIPLEX NETTYPES
not applicable 0 OFF A
0 or 1 1 OFF B
0 or 2 2 ON A
0 or 2 3 ON or OFF A
0 or 1 or 2 or 3 3 ON B
0 or 1 or 2 or 3 or 4 4 ON or OFF C