OSI/FTAM and OSI/APLMGR SCF Reference Manual

SCF Commands for Tandem FTAM
OSI/FTAM and OSI/APLMGR SCF Reference Manual—421943-001
3-94
STATUS PROCESS Considerations
STATUS PROCESS Considerations
•
If you specify indirect-process-name, the command is sent to the
APLMGR process, which in turn routes it to the specified initiator or responder
process. If you specify $process-name, the command goes directly to the
specified initiator or responder.
•
If the command with the DETAIL option is issued directly to an initiator or a
responder process, an additional field, OSIAPLMG Internal Name, is displayed.
This field contains the indirect process name for the initiator or responder process,
which indicates the subsystem to which the initiator or responder process belongs.
STATUS PROCESS Errors
The following table lists the most common errors that can occur during the processing of
the STATUS PROCESS command:
For more information on errors specific to APLMGR (OSIAPLMG errors having
positive error numbers), see Appendix B, SCF Error Messages for the APLMGR
Subsystem. For more information on errors specific to FTAM (OSIFTAM errors having
positive error numbers), see Appendix C, SCF Error Messages for the FTAM
Subsystem. For more information on common SCF error messages (errors having
negative error numbers), see the Subsystem Control Facility (SCF) Reference Manual
(for D-series releases) or the SCF Reference Manual for G-Series Releases.
Command Description
Expecting an existing SCF supported
object name or the character “(“
No process by the specified name could be
found. To display valid APLMGR process
names, use the following command:
LISTDEV OSIAPLMG
To display valid initiator and responder
process names, use the following
command:
LISTDEV OSIFTAM
To display valid initiator names only, use
the following command:
LISTDEV TYPE 55, 21
To display valid responder names only, use
the following command:
LISTDEV TYPE 55, 25
OSIAPLMG E-00017
Object object-name not found
The internal-name specified as part of
indirect-process-name was not
recognized by the APLMGR process as a
registered internal process name. To
display the currently registered process
names, use the following NAMES
command:
NAMES $appl-mgr-name.*.*