OSI/FTAM and OSI/APLMGR SCF Reference Manual

SCF Commands for Tandem FTAM
OSI/FTAM and OSI/APLMGR SCF Reference Manual—421943-001
3-115
SUSPEND PROCESS Errors
SUSPEND PROCESS Errors
The following table lists the most common errors that can occur during the processing of
the SUSPEND PROCESS command:
For more information on errors specific to APLMGR (OSIAPLMG errors having
positive error numbers), see Appendix B, SCF Error Messages for the APLMGR
Subsystem. For more information on errors specific to FTAM (OSIFTAM errors having
positive error numbers), see Appendix C, SCF Error Messages for the FTAM
Subsystem. For more information on common SCF error messages (errors having
negative error numbers), see the Subsystem Control Facility (SCF) Reference Manual
(for D-series releases) or the SCF Reference Manual for G-Series Releases.
SUSPEND PROCESS Examples
You can use the following command to suspend an APLMGR process named $AMGR
on the \MARS system:
SUSPEND PROCESS \MARS.$AMGR
To suspend an FTAM responder process named FTR1 that is controlled by
\MARS.$AMGR, you can issue the following command:
SUSPEND PROCESS \MARS.$AMGR.#FTAMR.FTR1
Error Message Description
Expecting an existing SCF supported object
name or the character “(“
No APLMGR process by the specified name
could be found. To display valid APLMGR
process names, use the following command:
LISTDEV OSIAPLMG
OSIAPLMG E-00017 Object object-name
not found
The internal-name specified as part of
indirect-process-name was not
recognized by the APLMGR process as a
registered internal process name. To display
the currently registered process names, use
the following NAMES command:
NAMES $appl-mgr-name.*.*
SCP E-00022 Security Violation for
process-name
You are not allowed to perform sensitive
commands. For further information on
sensitive commands, see Sensitive and
Nonsensitive Commands on page 1-9.
OSIAPLMG W-00016 Object
indirect-process-name is already in
{STARTED | STOPPED | SUSPENDED}
state
You issued a state-transition command that is
not permitted while the process is in its
current state. Use STATUS PROCESS to
display process states.
OSIFTAM E-00004 Command/object type
combination is not valid for this subsystem
You issued the command directly to the
initiator or responder process. Use the
indirect-process-name to specify the
desired initiator or responder process.