OSI/FTAM and OSI/APLMGR SCF Reference Manual

SCF Error Messages for the APLMGR Subsystem
OSI/FTAM and OSI/APLMGR SCF Reference Manual—421943-001
B-3
OSIAPLMG E00005 Command not valid for responder process.
Cause: You attempted to perform an ALLOWOPENS or a STOPOPENS
command on a responder process, but these commands are valid only
for initiator processes.
Effect: The command is not performed.
Recovery: Reissue the command, directing it to the appropriate initiator process.
To display valid initiator process names, issue the following command:
LISTDEV TYPE 55, 21
OSIAPLMG E00006 Command not valid for APLMGR process.
Cause: You attempted to perform an ALLOWOPENS or a STOPOPENS
command on an APLMGR process, but these commands are valid only
for initiator processes.
Effect: The command is not performed.
Recovery: Reissue the command, directing it to the appropriate initiator process.
To display valid initiator process names, issue the following command:
LISTDEV TYPE 55, 21
OSIAPLMG E00007 { MAXFTAMI | MAXFTAMR } limit of x
exceeded for indirect-process-name
Cause: You attempted to add an initiator or a responder process when the
configured maximum number of that type of process (MAXFTAMI or
MAXFTAMR) had already been defined in the MIB.
Effect: The command is not performed.
Recovery: Either issue an ALTER SUBSYS command to increase MAXFTAMI or
MAXFTAMR, or delete one or more configured processes of that type.