OSI/FTAM and OSI/APLMGR SCF Reference Manual

Introduction to SCF for Tandem FTAM
OSI/FTAM and OSI/APLMGR SCF Reference Manual—421943-001
1-13
SCF Error Messages
Error Message Examples
The following error can be returned by the APLMGR subsystem and is specific to the
APLMGR subsystem—no other subsystem generates this same error number and text.
Cause, effect, and recovery information for this error is given Appendix B, SCF Error
Messages for the APLMGR Subsystem. Note that the error number is a positive number.
In contrast, the following error can also be returned by the APLMGR subsystem, but the
error number and text is common to all subsystems using SCF: in other words, many
other subsystems might use this same -00003 error number and text. Additional
information on this error is given in the Subsystem Control Facility (SCF) Reference
Manual (for D-series releases) or the SCF Reference Manual for G-Series Releases.
Note that the error number is a negative number.
OSIAPLMG E00003 Command not allowed while object is in use.
OSIAPLMG E-00003 Command not allowed while object is in
{ STARTED } state [for object-name]
{ STOPPED }