APLMGR SCF Reference Manual

SCF Commands for Tandem FTAM

OSI/FTAM and OSI/APLMGR SCF Reference Manual—421943-001

3-5

ABORT PROCESS Errors

The following table lists the most common errors that can occur during the processing of

the ABORT PROCESS command:

For more information on errors specific to APLMGR (OSIAPLMG errors having

positive error numbers), see Appendix B, SCF Error Messages for the APLMGR

Subsystem. For more information on common SCF error messages (errors having

negative error numbers), see the Subsystem Control Facility (SCF) Reference Manual

(for D-series releases) or the SCF Reference Manual for G-Series Releases.

ABORT PROCESS Examples

You can use the following command to abort an APLMGR process named $AMGR

running in the \MARS system:

ABORT PROCESS \MARS.$AMGR

To abort an initiator process named FTI1 that is managed by the APLMGR process

named $AMGR, enter the command

ABORT PROCESS \MARS.$AMGR.#FTAMI.FTI1

Message Meaning

Expecting an existing SCF

supported object name or

the character “(“

No APLMGR process by the specified name could be found.

To display valid APLMGR process names, use the following

command:

LISTDEV OSIAPLMG

OSIAPLMG E-00017

Object object-name not

found

The internal-name specified as part of indirect-process-name

was not recognized by the APLMGR process as a registered

internal process name. To display the currently registered

process names, use the following NAMES command:

NAMES $appl-mgr-name.*.*

OSIFTAM E-00004

Command/object type

combination is not valid for

this subsystem

You issued the command directly to the initiator or responder

process. Use indirect-process-name to specify the

desired initiator or responder process.

SCP E-00022

Security Violation for

process-name

You are not allowed to perform sensitive commands. For

further information on sensitive commands, see Sensitive and

Nonsensitive Commands on page 1-9.