OSI/FTAM Configuration and Management Manual

Planning, Installing, and Configuring Tandem FTAM

OSI/FTAM Configuration and Management Manual—421944-001

3-49

Changing SUBSYS Object Attributes

When you install APLMGR, default values are automatically set for all SUBSYS

attributes to provide an initial configuration. In most instances, these defaults will not be

appropriate for your installation. In addition to the attributes you modified before you

started the APLMGR process, you may need to modify some other SUBSYS attribute

values.

Viewing the Default Configuration

Look at the values assigned to the SUBSYS object attributes. After viewing the

configuration, you can identify which attribute values you can change to tailor the

subsystem configuration to meet your individual system needs.

Issue the SCF INFO SUBSYS command to the APLMGR process to view the values for

APLMGR subsystem attributes. In Example FTAM Configuration

on page 3-38, you can

view the configuration of the APLMGR named $AMGR by issuing the following

command:

INFO SUBSYS $AMGR, DETAIL

If you issue the INFO SUBSYS command before you have made any changes to the

configuration through SCF, the command returns a display listing the attribute default

values set for the subsystem at installation. Note that this display does not represent all

entities presented in Figure 3-4

on page 3-8, because the values for those entities have

not yet been changed to reflect the Example FTAM Configuration on page 3-38.