OSI/FTAM Configuration and Management Manual

Example FTAM Configuration Command Files
OSI/FTAM Configuration and Management Manual—421944-001
A-5
VFS Profile
Table A-4 presents attribute values for the two responder processes. Again, the values in
this table represent the configured installation using the examples in Section 3, Planning,
Installing, and Configuring Tandem FTAM, Section 4, Managing the FTAM
Configuration, and Section 5, Monitoring FTAM Performance. The process identified in
the first column is fully qualified as $AMGR.#FTAMR.FTR1 or
$AMGR.#FTAMR.FTR2. The profile displayed in the table (VFS1) is fully qualified as
$AMGR.#VFS.VFS1.
VFS Profile
The example VFS profile, VFS1, has the attribute values listed in Table A-5.
Table A-4. Attribute Values for Example FTAM Responder Processes
FTAM Responder Process
FTR1 FTR2
Guardian Name $FTR1 $FTR2
CPU 11
Backup CPU 32
Priority 145 * 145 *
Threshold Value 0 * 0*
Swap Disk $DATA $DATA
Maximum Associations 3 * 3 *
Maximum Attaches 31
Profile VFS1 VFS1
Subdevice Regeneration ON * ON *
* Default value set by the system
Table A-5. Attribute Values for VFS Profile
Attribute Description
Value Set for This
Example
COMNAME
(COM-NAME?)
Name used by the OSI manager process
to locate the OSI address of a process in
the OSI/AS MIB LDIB.
APPL1A
DEFUSER User ID and password that the responder
uses if the remote user does not specify a
user ID and password.
USER.BOB,passwd