OSI/FTAM Configuration and Management Manual

FTAM Management Environment
OSI/FTAM Configuration and Management Manual—421944-001
2-4
Using SCF to Manage Tandem FTAM
When you enter an SCF command at your terminal, you also must specify the object on
which the command is to act. Command/object combinations allow you to configure,
monitor, and control the Tandem FTAM software. SCF Objects on page 2-9 discusses
SCF commands and objects for the APLMGR and FTAM subsystems.
Command reference information for the SCF interface to the APLMGR and FTAM
subsystems is provided in the OSI/FTAM and OSI/APLMGR SCF Reference Manual.
You might encounter situations in which you need to enter a long sequence of SCF
commands or in which you have a sequence of SCF commands that you perform
routinely. In these situations, consider setting up a file containing the command
sequence so that you can run it automatically. You can run such an SCF command file
either by specifying the file as an IN file in the SCF command line or by issuing the SCF
OBEY command. Appendix A, Example FTAM Configuration Command Files
,
provides examples of typical SCF command files used to configure Tandem FTAM. For
detailed information on using command files with SCF, see the Subsystem Control
Facility (SCF) Reference Manual (for D-series releases) or the SCF Reference Manual
for G-Series Releases.
Figure 2-2. SCF Management Interface
008CDT .CDD
Tandem FTAM
SCF
Commands
SCF
Displays
SCF
SCP
APLMGR
Initiator
Responder