OSI/FTAM Programming Reference Manual

FTM Procedures
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
4-75
FTM_ERASE_CNF_
FTM_ERASE_CNF_
This procedure allows you to retrieve the responder’s response to the application’s
request to erase the specified FADU of the previously selected and opened file.
error return value
INT
indicates the outcome of the call. For a list of defined values, see Appendix B,
NonStop FTAM Initiator Error Messages.
cepi input
INT:value
is the connection endpoint identifier (CEPI) used to identify the specific
association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_
procedure for this association. For additional information on using the cepi
parameter, see the OSI/FTAM Programming Guide.
cepi is a required parameter.
action-result output
INT(32) .EXT:ref:1
summarizes information available in the diagnostic parameter. The
action-result value is never less severe than the most severe diagnostic
value. Valid values are the following:
ZFTM-VAL-ACTION-SUCCESS
ZFTM-VAL-ACTION-FAILURE
A value of ZFTM-VAL-ACTION-SUCCESS indicates that the operation was
successful. Even for a successful operation, the diagnostic parameter might
include one or more informative messages. A value of ZFTM-VAL-ACTION-
FAILURE indicates that the operation was not successful, and diagnostic is
likely to contain one or more diagnostic messages.
action-result is an optional parameter.
diagnostic output
INT .EXT:ref:(ZFTM-DDL-DIAGNOSTIC)
provides information that qualifies the success or explains the failure of a
requested action. For a complete list of possible diagnostic values, see
Appendix C, ISO FTAM Diagnostic Messages.
error := FTM_ERASE_CNF_ ( cepi ! I
, [ action-result ] ! O
, [ diagnostic ] ) ; ! O