OSI/FTAM Programming Reference Manual

FTM Procedures
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
4-98
FTM_INITIALIZE_REQ_
extended segment that the FTAM API uses to maintain the context information for
all the FTAM associations your application establishes.
•
You must issue an MFM_AWAITIOX_ call to complete the nowait I/O operation if
you set the nowait operating mode in the FTM_INITIALIZE_REQ_ call.
•
The local-appl and remote-appl parameters each consist of the common
name (OSI/AS application name) and the corresponding OSI address. If you
specify only the common name, OSI/AS supplies the OSI address. If you specify
the OSI address, OSI/AS ignores any common name you specify.
•
The mandatory parameter Presentation Context Management (as specified in ISO
8571-3) is not provided because the underlying stack does not support this
functionality. This parameter is not available to your application and its value is
always FALSE.
•
The mandatory parameter FTAM Quality of Service (as specified in ISO 8571-3) is
not provided because the NonStop FTAM implementation does not support
recovery. The FTAM Quality of Service parameter is not available to your
application and its value will always be NO-RECOVERY.
•
The mandatory parameter Communications Quality of Service (as specified in ISO
8571-3) is not provided because the NonStop FTAM implementation does not
support recovery. This parameter is not available to your application because the
underlying stack does not support this functionality.
Errors
For cause, effect, and recovery information on these errors, see Appendix B, NonStop
FTAM Initiator Error Messages.
Table 4-29. Possible FTAM Initiator Errors for the FTM_INITIALIZE_REQ_
Procedure
Error Code FTAM Initiator Error
- 6000 ZFTM-ERR-INTERNAL
- 6017 ZFTM-ERR-INVALID-IF-VERSION
- 6018 ZFTM-ERR-INVALID-FIELD-VERSION
- 6019 ZFTM-ERR-BAD-APS-STATUS