OSI/FTAM Programming Reference Manual

FTM Procedures

HP NonStop OSI/FTAM Programming Reference Manual—528611-001

4-120

FTM_P_ABORT_IND_

This procedure allows you to retrieve information indicating that the association has

been aborted somewhere in the OSI stack, either on the NonStop system or on the

remote responding system.

error return value

INT

indicates the outcome of the call. For a list of defined values, see Appendix B,

NonStop FTAM Initiator Error Messages.

cepi input

INT:value

is the connection endpoint identifier (CEPI) used to identify the specific

association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_

procedure for this association. For additional information on using the cepi

parameter, see the OSI/FTAM Programming Guide.

cepi is a required parameter.

action-result output

INT(32) .EXT:ref:1

summarizes information available in the diagnostic parameter. The action-

result value is never less severe than the most severe diagnostic value. Valid

values are the following:

ZFTM-VAL-ACTION-SUCCESS

ZFTM-VAL-ACTION-FAILURE

A value of ZFTM-VAL-ACTION-SUCCESS indicates that the operation was

successful. Even for a successful operation, the diagnostic parameter might

include one or more informative messages. A value of ZFTM-VAL-ACTION-

FAILURE indicates that the operation was not successful, and diagnostic is

likely to contain one or more diagnostic messages.

action-result is an optional parameter.

diagnostic output

INT .EXT:ref:(ZFTM-DDL-DIAGNOSTIC)

error := FTM_P_ABORT_IND_ ( cepi ! I

, [ action-result ] ! O

, [ diagnostic ] ) ; ! O