OSI/FTAM Programming Reference Manual

NonStop FTAM Initiator Error Messages
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
B-7
APS Error Codes
-104
Cause. An internal error has occurred.
Subcodes. A number of undocumented subcodes internal to NonStop Kernel are
possible.
Recovery. Trace the TAPS process and note the error and subcode, if any. Follow the
standard procedures at your site for contacting the appropriate support personnel.
These procedures might involve contacting your local HP support analyst.
-105
Cause. The parameters you supplied with an APS or FTM procedure contained one or
more errors.
Subcodes. The subcode indicates the parameter concerned. For FTM-procedure
parameters, see Table B-4 on page B-16 under error code -137, later in this
subsection, and for APS procedure parameters, the OSI/AS Programming Manual.
Recovery. Correct your use of parameters, rebuild the application, and then retry the
operation.
-106
Cause. Too many requests are pending. You cannot have more than one primitive
request and one event receive request pending at any given time for one CEPI
(connection endpoint identifier).
Subcodes. None.
Recovery. Await completion of the pending primitive request before issuing another
primitive request.
ZAPS-ERR-INTERNAL
ZAPS-ERR-PARAMETER
ZAPS-ERR-TOO-MANY-PENDING