OSI/FTAM Programming Reference Manual

NonStop FTAM Initiator Error Messages
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
B-20
FTAM Initiator Error Codes
PROC-MODE-
INCNSTNT
-6005 Processing mode inconsistent with requested access
FADU-ID-INVALID -6006 FADU ID invalid
FADU-OP-INCNSTNT -6007 FADU operation inconsistent with processing mode
PROC-MODE-NOT-
AVAIL
-6008 Processing mode not requested
ACCESS-CNTXT-
INVALID
-6009 Access context invalid
INVALID-DATA -6010 Invalid data
SERV-NOT-
NEGOTIATED
-6012 Service not negotiated
INVALID-IF-VERSION -6017 FTAM initiator/FTAM API interface version mismatch
INVALID-FIELD-
VERSION
-6018 FTAM initiator/FTAM API field version mismatch
BAD-APS-STATUS -6019 Bad APS status
RESRC-DCB-ALLOC -6021 Resource data control block allocation failed
CONNECTION-
ABORTED
-6022 Connection aborted
ATTR-GRP-NOT-NEG -6024 Attribute group not negotiated
PRIVATE-USE-NOT-
SUPP
-6025 Private use not supported
LOCATE-DOCTYPE -6026 Locate not supported by document type
DATA-XFER-
CANCELLED
-6030 Data transfer canceled
ACSE-FAILURE -6032 ACSE Layer failure
SU-ABORTED -6036 Association SU aborted via SCF command
DATA-VALUE-TOO-
SMALL
-6037 Data-value parameter specified on FTM_DATA_IND_
is too small
API-FS-ERROR -6038 FTAM API has reported an error in communicating
with FTAM initiator
EMPTY-ASSOC-CNF -6039 Initialize confirm was received without user data
Table B-5. FTAM Initiator Error Codes (page 2 of 2)
Constant (ZFTM-ERR-) Value Meaning