OSI/FTAM Programming Reference Manual

FTM Procedures
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
4-27
FTM_CHANGE_ATTRIB_REQ_
•
To complete this procedure call successfully, the association must be in the
file-selection regime.
•
For the remote responder to respond affirmatively to the change-attribute primitive,
the change-attribute field of the permitted-actions attribute of this file must be set to
ON.
•
You must issue an MFM_AWAITIOX_ call to complete the nowait I/O operation if
you set the nowait operating mode in the FTM_INITIALIZE_REQ_ call.
Errors
For cause, effect, and recovery information on these errors, see Appendix B, NonStop
FTAM Initiator Error Messages.
The following table lists common errors that can occur on the
FTM_CHANGE_ATTRIB_REQ_ procedure call.
Table 4-8. Possible FTAM Initiator Errors for the FTM_CHANGE_ATTRIB_REQ_
Procedure
Error Code FTAM Initiator Error
- 6000 ZFTM-ERR-INTERNAL
- 6001 ZFTM-ERR-OUT-OF-SEQUENCE
- 6002 ZFTM-ERR-FU-NOT-NEGOTIATED
- 6004 ZFTM-ERR-ACCESS-NOT-AVAIL
- 6017 ZFTM-ERR-INVALID-IF-VERSION
- 6018 ZFTM-ERR-INVALID-FIELD-VERSION
- 6019 ZFTM-ERR-BAD-APS-STATUS
- 6022 ZFTM-ERR-CONNECTION-ABORTED
- 6024 ZFTM-ERR-ATTR-GRP-NOT-NEG
- 6025 ZFTM-ERR-PRIVATE-USE-NOT-SUPP
- 6036 ZFTM-ERR-SU-ABORTED