OSI/FTAM Programming Reference Manual

FTM Procedures

HP NonStop OSI/FTAM Programming Reference Manual—528611-001

4-41

FTM_CREATE_CNF_

This procedure allows you to retrieve the remote responder’s response to the initiator

request to create and select a file in a file storage system with which an association

has been established.

error return value

INT

indicates the outcome of the call. For a list of defined values, see Appendix B,

NonStop FTAM Initiator Error Messages.

cepi input

INT:value

is the connection endpoint identifier (CEPI) used to identify the specific

association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_

procedure for this association. For additional information on using the cepi

parameter, see the OSI/FTAM Programming Guide.

cepi is a required parameter.

state-result output

INT(32) . EXT:ref:1

indicates if the responder established the file-selection regime as requested. Valid

values are as follows:

ZFTM-VAL-STATE-SUCCESS

ZFTM-VAL-STATE-FAILURE

state-result is an optional parameter.

action-result output

INT(32) .EXT:ref:1

summarizes information available in the diagnostic parameter. The

action-result value is never less severe than the most severe diagnostic

value. Valid values are the following:

ZFTM-VAL-ACTION-SUCCESS

ZFTM-VAL-ACTION-FAILURE

error := FTM_CREATE_CNF_ ( cepi ! I

, [ state-result ] ! O

, [ action-result ] ! O

, [ initial-attrib ] ! O

, [ diagnostic ] ) ; ! O