OSI/MHS Administrative Utility (AU) Manual

About This Manual
OSI/MHS Administrative Utility (AU) Manual—424826-001
vii
Related Manuals
For background information on the Compaq environment, you can read the following
manuals:
•
Introduction to Compaq Networking and Data Communications, which provides an
overview of Compaq networking and data communications products.
•
Introduction to Distributed Systems Management (DSM), which introduces the
products and components called, collectively, Distributed Systems Management. It
also discusses subsystem enhancements to support DSM.
•
Subsystem Control Facility (SCF) Reference Manual, which describes the operation
of SCF and tells system and network managers how to use SCF to configure,
control, and inquire about supported data communications subsystems.
For information specific to OSI/MHS, you may want to read the following manuals:
•
OSI/MHS Configuration and Management Manual, which describes how to plan,
install, configure, manage, and maintain a Compaq OSI/MHS subsystem.
•
OSI/MHS Management Programming Manual, which describes how to write
management programs that control and monitor the OSI/MHS subsystem.
•
OSI/MHS SCF Reference Manual, which tells system and network managers and
operators how to use SCF commands to install, control, and inquire about the
Compaq OSI/MHS subsystem. This manual also contains PTrace information and
descriptions of attributes and screen displays.
For information on event and problem management, you can read the following
manuals:
•
PTrace Reference Manual, which tells system and network managers how to display
the trace files created by the SCF TRACE command.
•
Event Management Service (EMS) Manual, which tells system and network
managers how to write event-message filters to select event messages of particular
interest, and how to distribute event messages to various destinations.
•
Operator Messages Manual describes system messages and explains possible causes
of each message, discusses each error’s effect on the system, and suggests corrective
actions.
For information about Pathway configuration for the AU, you can refer to the following
manual:
•
Pathway/TS TCP and Terminal Programming Guide, which is a guide for
programmers who are writing SCREEN COBOL requesters to be used in Pathway
applications.
•
NonStop TCP/IP and IPX/SPX Programming Manual, which describes how to
develop socket applications for the Compaq NonStop TCP/IP and Compaq NonStop
IPX/SPX data communications subsystems.