OSI/MHS Configuration and Management Manual

Configuring Your OSI/MHS Subsystem
OSI/MHS Configuration and Management Manual—424827-003
5-14
Configuring MTA2
•
MTA-NAME (MTANAME)—specifies the MTA name of this OSI/MHS subsystem.
This is used by adjacent MTAs to identify this MTA.
Configuring MTA2
MTA2 has three MR groups connected to the OSI/AS services by a common OSI
address. This MTA operates as a network relay. Figure 5-3 shows the topology and
major components of the MTA2 configuration.
The major features of the MTA2 configuration are:
•
It embodies the basic configuration of a network relay or switch.
•
It has two adjacent MTAs: MTA1 and MTA3 (there are no other MTAs).
•
Three MR groups share one OSI address to receive association requests from
MTA1 and MTA3. This is a multigroup configuration.
•
It uses an X.25 normal mode connection.
•
Two routes are defined to each adjacent MTA.
•
Backup routes are defined.
Objects and Attributes
Figure 5-4 shows the OSI/MHS objects and their attributes needed to configure MTA2.
This figure is a visual summary of the configuration attributes for MTA2.
Figure 5-3. MTA2 Components
032VST .VS D
MR 2MR 1 MR 3
MTA2
MTA1 MTA3
X.25
OSI/AS
OSI/TS
X25AM