OSI/MHS Configuration and Management Manual

Configuring Your OSI/MHS Subsystem

OSI/MHS Configuration and Management Manual—424827-003

5-21

Installation and Configuration Files for MTA3

MTA3 requires the following files for installation and configuration:

•

An installation file. The installation file contains the keywords and keyword values

needed to install and name the databases and other files for MTA3. After creating

this file online, you execute it as explained in Section 4, Installing Your OSI/MHS

Subsystem.

•

An OSI/MHS configuration file. The OSI/MHS configuration file contains all of the

SCF commands needed to configure the objects for MTA3.

•

OSI/AS and OSI/TS configuration file.This file contains the OSI addresses for

MTA3. It also defines the connections to network services, such as X.25.

Appendix A, Examples of Configuration Files, contains the SCF command file

needed to configure OSI/AS and OSI/TS for MTA3. It also includes an overview of

the OSI addresses for MTA3.

Configuring MTA1

MTA1 has four MR groups connected to OSI/AS by three OSI addresses. It has two GI

groups, two LO groups, four MS groups, and four RS groups. The four RS groups are

connected to OSI/AS over two addresses. MTA1 has a Transfer X400 gateway and a

general user gateway. Figure 5-7 shows the topology and major components of the

MTA1 configuration.