OSI/MHS Configuration and Management Manual

Troubleshooting Your OSI/MHS Subsystem
OSI/MHS Configuration and Management Manual—424827-003
9-9
Symptoms of Interconnection Problems
This event message is produced only if it was enabled (using SCF). Here are some
examples of event message 35:
94-12-02 12:20:46 \CS7.$RK12 TANDEM.MHS.D20 000035
RTS Incoming Association Rejected; id(0); Reason: Unknown calling
Session Address;
Remote:
NSAP=51
TSEL=51
SSEL=4B5353454C3141
PSEL=
Local:
NSAP=52
TSEL=52
SSEL=4B5353454C3241
PSEL=
94-12-02 12:20:46 \CS7.$RK11 TANDEM.MHS.D20 000035
RTS Outgoing Association Rejected; id(0); Reason: Validation
Failure;
Remote:
NSAP=52
TSEL=52
SSEL=4B5353454C3241
PSEL=
Local:
NSAP=51
TSEL=51
SSEL=4B5353454C3141
PSEL=
For a complete description of this event message, refer to the OSI/MHS Management
Programming Manual.
Statistics Counter Problem
The SCF command that displays the relevant statistics counters for RTS processes is
STATS PROCESS. The following is an example of the output from a STATS
PROCESS command applied to an RTS process:
MHS stats PROCESS RTS \CS7.$RK11:
Reset-time........ 02 Dec 1994, 12:16:06.211
Sample-time....... 02 Dec 1994, 12:22:55.285
CPU............... 0 Protocol-errors... 0
Msgs-sent......... 0 Msg-bytes-sent.... 0
Msgs-received..... 0 Msg-bytes-received 0
Inc-assocs-open... 0 Out-assocs-open... 0
Inc-assocs-closed. 0 Out-assocs-closed. 0
Inc-assocs-rej.... 0 Out-assocs-rej.... 190
Inc-assocs-fail... 0 Out-assocs-fail... 0
Inc-assocs-recovs. 0 Out-assocs-recovs. 0
Inc-trans-fail.... 0 Out-trans-fail.... 0
Transfer-timeouts. 0 Recovery-timeouts. 0
U-ABORT........... 0 P-ABORT........... 0
U-EXCEPT.......... 0 P-EXCEPT........ 0
A bad connection or a problem with a connection is shown by an increase in any of the
counters indicated in boldface above. The counters prefixed with Inc-assocs- are for
incoming associations, and those prefixed with Out-assocs- are for outgoing
associations. The incoming association counters are used when OSI/MHS is the
responder of an association, and the outgoing association counters are used when